IMPORTANT INSTRUCTION NOTICE TO THE RADIO DEALER

FOR CONNECTING PILOTUNER TO ANY SET WITHOUT PHONO OUTLET

 The Underwriters Laboratories will not permit us to include in our FM PILTOTUNER service booklet any instructions to the layman concerning the connection of the tuner to a radio receiver without phono or phono outlet, since this type of installation requires wiring directly into the circuit of the radio receiver. Therefore, we are sending you these instructions separately in this form for the use of your radio service technician.

INSTALLATION PROCEDURE

Attach center wire and outside shield wire of PILOTUNER connector cable to terminals #7 and #6 respectively of the PILOTUNER, following instructions in Par. III of service booklet.

Modify the radio receiver circuit as follows: (See diagram below)

Unsolder the wire attached to the ungrounded side of the volume control, and attach center wire of PILOTUNER connector cable to this spot. The outside shielded wire of the radio receiver. The disconnected lead from the volume control should be soldered to the center wire of a second connector cable, and through it connected to terminal #5 of the PILOTUNER. The shielded wire of this second cable should also be soldered to chassis. The radio receiver will then operate normally on standard broadcast (AM), whenever the ON-OFF switch of the FM PILOTUNER is in the OFF position.

Pilot Radio Corporation Long Island City 1, New York